CLI Commands
4.20 W
SCALANCE W1750D CLI
704 Function Manual, 03/2019, C79000-G8976-C452-04
Usage Guidelines
Use this command to configure a WISPr authentication profile for the captive portal users.
Scalance W supports the following smart clients:
● iPass
● Boingo
These smart clients enable client authentication and roaming between hotspots by
embedding iPass Generic Interface Specification (GIS) redirect, authentication, and logoff
messages within HTML messages that are sent to the AP.
The WISPr RADIUS attributes and configuration parameters are specific to the RADIUS
server used by your ISP for the WISPr authentication. Contact your ISP to determine the
parameter values for WISPr profile configuration. You can find a list of ISO and ITU country
and area codes at the ISO and ITU websites (www.iso.org and http://www.itu.int).
Example
The following commands configure a WISPr authentication profile:
(scalance)(config)# wlan wispr-profile
(scalance)(WISPr)# wispr-location-id-ac 408
(scalance)(WISPr)# wispr-location-id-cc 1
(scalance)(WISPr)# wispr-location-id-isocc US
(scalance)(WISPr)# wispr-location-id-network wispr
(scalance)(WISPr)# wispr-location-name-location airport
(scalance)(WISPr)# wispr-location-name-operator-name KNP
(scalance)(WISPr)# end
(scalance)# commit apply
Command Information
Configuration mode and WISPr profile sub-mode.
4.20.11 wifi0-mode
Description
This command configures an AP to function in the Access, Monitor, or Spectrum Monitor
mode.
To Next Page
Loading...
