Siemens SCALANCE W1750D CLI - Wificall-Dns-Pattern

CLI Commands
4.20 W
SCALANCE W1750D CLI
702 Function Manual, 03/2019, C79000-G8976-C452-04
4.20.9 wificall-dns-pattern
Description
This command configures Wi-Fi Calling. Wi-Fi Calling is enabled by default. The DSCP value
for the voice session is 48 (without ACP) and 46 (with ACP).
Syntax
wificall-dns-pattern <dns_pattern>
no…
Parameter
Description
Range
Default
<dns_pattern>
Configure the DNS pattern for the carrier. A maxi-
mum of 10 DNS patterns can be configured. DNS
patterns for known carriers are configured by de-
fault. Default built-in patterns are:
• 3 HK - wlan.three.com.hk
• ATT - epdg.epc.att.net
• Rogers-
epdg.epc.mnc720.mcc302.pub.3gppnetwork.or
g
• SmarTone-
epdg.epc.mnc006.mcc454.pub.3gppnetwork.or
g
• Sprint - primgw.vowifi2.spcsdns.net
• T-Mobile -
ss.epdg.epc.mnc260.mcc310.pub.3gppnetwork.
org
• Verizon - wo.vzwwo.com
If the ePDG FQDN of the carrier does not match
with the default patterns, use this option to con-
figure the DNS pattern for the carrier.
NOTE
: The DNS IP address that AP learns for Wi-
Fi calling age out automatically, if there was no
DNS query or response matching that IP for more
than seven days.
priority voice:
0-62
priority
voice: 46
no…
Remove the configuration
—
—
Usage Guidelines
Use this command to configure a DNS pattern for the wi-fi calling client.
Example
The following example configures the DNS pattern for a Wi-Fi calling client:
(scalance)(config)# wificall-dns-pattern xo.xyz.com