Siemens SCALANCE W1750D CLI - Show Log Vpn-Tunnel-Backup

CLI Commands
4.16 S
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
543
tunnel 0.0.0.0 RC_ERROR_IKEP2_PKT1 debug-error:-8949
2017-04-19 10:07:49 [primary tunnel] tunnel_err_msg_recv(1588): Error!!! Received
RC_OPCODE_
ERROR peer public ip 10.17.132.51 tunnel ip 0.0.0.0, controller ip 0.0.0.0,
RC_ERROR_IKEP2_
PKT1 debug-error:-8949 (ERR_IKE_TIMEOUT)
Command Information
AP Platform
Command Mode
All platforms
Privileged EXEC mode
4.16.177 show log vpn-tunnel-backup
Description
This command shows the backup VPN tunnel status for the AP.
Syntax
show log vpn-tunnel-backup
Parameter
Description
backup tunnel
Displays the log output from the backup VPN tunnel.
Usage Guidelines
Use this command to view a table of a backup VPN tunnel status.
Example
The following example shows the output of show log vpn-tunnel-backup command:
2017-05-02 06:49:53 [backup tunnel] tunnel_config_remove(2896): configure remove,
tunnel backup
tunnel, type ipsec tunnel
2017-05-02 06:49:53 [backup tunnel] SM Handler not needed for state TUNNEL_STATE_INIT
event TUNNEL_EVENT_TUNNEL_DISCONNECT
2017-05-02 06:49:53 [backup tunnel] tunnel_unregister_action(2372): unregister ipsec
action. 2017-05-02 06:49:53 [backup tunnel] tunnel_unregister_action(2388): ipsec
client space already free.
E_TIMEOUT)