Siemens SCALANCE W1750D CLI - Show Ap Debug Spanning-Tree

CLI Commands
4.16 S
SCALANCE W1750D CLI
364 Function Manual, 03/2019, C79000-G8976-C452-04
Command Information
AP Platform
Command Mode
All platforms
Privileged EXEC mode
4.16.70 show ap debug spanning-tree
Description
This command displays the STP information for an AP.
Syntax
show ap debug spanning-tree
Usage Guidelines
Use this command to view STP details on an AP. STP is enabled for a wired port profile to
ensure that there are no loops in any bridged Ethernet network. STP operates on all
downlink ports, regardless of forwarding mode. STP will not operate on the uplink port and is
supported only on APs with three or more ports.
Example
The following example shows the output displayed for the show ap debug spanning-tree
command when there are no STP devices found:
stpdev
bridge id
f000.000000000000
designated root
f000.000000000000
root port
0
path cost
0
max age
20.00
bridge max age
18.08
hello time
2.00
bridge hello time
10.00
forward delay
34.04
bridge forward delay
15.00
ageing time
13.29
hello timer
0.82
tcn timer
0.00
topology change
timer
0.00
gc timer
22.55
flags
Command Information
AP Platform
Command Mode
All platforms
Privileged EXEC mode