Siemens SCALANCE W1750D CLI - Show Ap Monitor

CLI Commands
4.16 S
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
377
Command Information
AP Platform
Command Mode
All platforms
Privileged EXEC mode
4.16.81 show ap monitor
Description
This command shows information for AP AMs.
Syntax
show ap monitor {active-laser-beams|ap-list|ap-wired-mac <mac>|arp-cache|arp-vlan-
cache|containment-info| enet-wired-mac <mac>| ids-state <type>| pot-ap-list | pot-
sta-list| rogue-ap <mac>| routers| scan-info| sta-list| state <mac>| stats
<mac>|status| swarm-radio-list}
Parameter
Description
active-laser-beams
Shows active laser beam generators. The output of this command shows
a list of all APs that are actively performing policy enforcement contain-
ment such as rogue containment. This command can tell us which AP is
sending out deauthorization frames, although it does not specify which
AP is being contained.
ap-list
Shows list of APs being monitored.
ap-wired-mac
Shows the MAC address of the wired AP.
arp-cache
Shows ARP Cache of learned IP to MAC binding
arp-vlan-cache
Shows ARP cache that contains VLAN tags.