Siemens SCALANCE W1750D CLI - Vpn Ikepsk; Vpn Monitor-Pkt-Lost-Cnt

CLI Commands
4.19 V
SCALANCE W1750D CLI
656 Function Manual, 03/2019, C79000-G8976-C452-04
4.19.9 vpn ikepsk
Description
This command configures user credentials for the VPN connection.
Syntax
vpn ikepsk <ikepsk> username <username> password <password>
no…
Parameter
Description
vpn ikepsk <ikepsk>
Specifies an IKE authentication for VPN connection using PSKs.
username <username>
Defines a username that enables access to VPN.
password <password>
Defines a password that enables access to VPN.
no…
Removes the configuration.
Usage Guidelines
Use this command to configure user credentials to establish VPN connection.
Example
The following commands enable user access to VPN connection.
(scalance)(config)# vpn ikepsk secretKey username User1 password password123
(scalance)(config)# end
(scalance)# commit apply
Command Information
AP Platform
Command Mode
All platforms
Configuration mode
4.19.10 vpn monitor-pkt-lost-cnt
Description
This command configures the number of lost packets after which the AP can determine that
the VPN connection is not available.