Siemens SCALANCE W1750D CLI - Ap-Installation; Apply

CLI Commands
4.1 A
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
49
4.1.25 ap-installation
Description
This command tests a configured authentication server.
Syntax
ap-installation default|indoor|outdoor
Parameter
Description
Range
Default
ap-installation
Specify the type of installation (indoor
or outdoor). The default parameter
automatically selects an installation
mode based upon the AP model type.
default
indoor
outdoor
default
Usage Guidelines
Use this command to provision an outdoor AP into an indoor AP or vice versa. The AP
needs to be rebooted for the configuration to take effect.
Example
The following example changes the installation type of the AP from default to outdoor:
(scalance)# ap-installation outdoor
Command Information
AP Platform
Command Mode
All platforms Privileged EXEC mode
4.1.26 apply
Description
This command is used to save or apply the configuration settings on the AP.
Syntax
apply {cplogo-install| cplogo-uninstall| debug-command| delta-config}
Parameter
Description
cplogo-install
Installs the captive portal logo on the AP.
cplogo-uninstall
Uninstalls the captive portal logo on the AP.