Siemens SCALANCE W1750D CLI - Show Attack

CLI Commands
4.16 S
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
405
Usage Guidelines
Use this command to view the ARM messages sent or received by the Virtual Controller.
Example
The following example shows the output of show arp command
IP address
HW type
Flags
HW address
Mask
Device
192.168.10.2
0x1
0x6
D8:C7:C8:C4:42:98
*
br0
10.17.88.2
0x1
0x2
00:0B:86:40:1C:A0
*
br0
The output of this command includes the following information:
Parameter
Description
IP address
Displays the IP address of the device.
HW Type
Displays the type of the device.
Flags
Displays any flags for this AP.
HW address
Displays the MAC address of the device.
Mask
Displays the network mask or the IP address range.
Device
Displays the device used to send ARP requests and replies.
Command Information
AP Platform
Command Mode
All platforms Privileged EXEC mode
4.16.93 show attack
Description
This command displays information about firewall settings configured on an AP to protect the
network against wired attacks such as ARP attacks or malformed DHCP packets.
Syntax
show attack {config| stats}
Parameter
Description
config
Displays firewall configuration details to protect the network from wired
attacks.
stats
Displays attack counters.