Siemens SCALANCE W1750D CLI - Page 406

CLI Commands
4.16 S
SCALANCE W1750D CLI
406 Function Manual, 03/2019, C79000-G8976-C452-04
Usage Guidelines
Use this command to view firewall configuration details or attack counters enabled on an AP
to protect the network from ARP attacks and malformed DHCP packets.
Example
The following example shows the output of show attack config command:
Current Attack
--------------
Attack Status
------ ------
drop-bad-arp Disabled
fix-dhcp Disabled
poison-check Enabled
The output of this command indicates if the firewall settings to block invalid ARP packets and
fix malformed DHCP packets are enabled. You can also view the status of the Poison-check
parameter, which triggers an alert to notify the user about the ARP poisoning when enabled.
The following example output for the
show attack stats command shows the attack counters:
attack counters
--------------------------------------
Counter Value
------- -------
arp packet counter 0
drop bad arp packet counter 0
dhcp response packet counter 0
fixed bad dhcp packet counter 0
send arp attack alert counter 0
send dhcp attack alert counter 0
arp poison check counter 0
garp send check counter 1628
Command Information
AP Platform
Command Mode
All platforms
Privileged EXEC mode