Siemens SCALANCE W1750D CLI - Swarm-Mode

CLI Commands
4.16 S
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
629
Example
(scalance)# a-channel 44 18
Command Information
AP Platform
Command Mode
All platforms
Privileged EXEC mode
4.16.242 swarm-mode
Description
This command allows you to provision an AP in the standalone or cluster mode.
Syntax
swarm-mode <mode>
Parameter
Description
Range
<mode>
Provisions the AP in the standalone or cluster mode. The
swarm-mode standalone
command converts the AP to the
standalone mode, whereas the
swarm- mode cluster
com-
mand converts it to the cluster mode.
standalone or cluster
Usage Guidelines
When an AP is converted to the standalone mode, it cannot join a cluster of APs even if the
AP is in the same VLAN. If the AP is in the cluster mode, it can form a cluster with other
Virtual Controller APs in the same VLAN.
Example
The following command allows you to convert an AP to a standalone AP:
(scalance)# swarm-mode standalone
Command Information
AP Platform
Command Mode
All platforms
Privileged EXEC mode