Siemens SCALANCE W1750D CLI - Show Ap Debug Driver-Config

CLI Commands
4.16 S
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
343
Parameter
Description
Auth-Fails
Displays the number of times the client failed to authenticate.
Auth-Timeout
Displays if client authentication timeout details.
Reauths
Displays the reauthentication attempts if any.
Supp-Naks
Displays the number of supplementary NAKs.
UkeyRot
Displays the unicast key rotation details.
MkeyRot
Displays the multicast key rotation details.
802.1X counters
Displays the 802.1X authentication counters.
Command Information
AP Platform
Command Mode
All platforms
Privileged EXEC mode
4.16.58 show ap debug driver-config
Description
This command displays AP driver configuration.
Syntax
show ap debug driver-config
Usage Guidelines
Use this command to review configuration changes made since the AP driver was last reset.
Example
The show ap debug driver-config command displays the BSSID, SSID, and radio
configuration details associated with the AP driver. The following output is displayed for the
show ap debug driver-config command:
Downloaded Config for WIFI 0
----------------------------
Item Value
---- -----
BSSID d8:c7:c8:3d:42:12
LMS IP
Master IP 0.0.0.0
Mode AP Mode