Siemens SCALANCE W1750D CLI - Show Ap Debug Lldp Neighbor

CLI Commands
4.16 S
SCALANCE W1750D CLI
350 Function Manual, 03/2019, C79000-G8976-C452-04
Command Information
AP Platform
Command Mode
All platforms
Privileged EXEC mode
4.16.60 show ap debug lldp neighbor
Description
This command displays LLDP neighbors for a specific AP or all APs sending or receiving
LLDP PDUs.
Syntax
show ap debug lldp neighbor [interface <name> detail]
Parameter
Description
<name>
Displays the name of the AP interface sending or receiv- ing LLDP PDUs.
detail
Displays details about the interface and number of neighbors.
Usage Guidelines
By default, this command displays LLDP neighbors for the entire list of LLDP interfaces.
Include the IP address of an AP to display neighbor information only for that one device.
Example
The following example shows the output of show ap debug lldp neighbor command.
(scalance)# show ap debug lldp neighbor
Capability codes: (R)Router, (B)Bridge, (A)Access Point, (P)Phone, (O)Other LLDP
Neighbor Information
-------------------------
Interface Neighbor ID Capabilities Remote Interface Expiry-Time (Secs)
--------- ----------- ------------ ---------------- ------------------
eth0 00:0b:86:6b:57:80 B:R GE0/0/22 93
The output of this command includes the following information:
Parameter
Description
<interface>
Indicates the interface on the AP sending or receiving LLDP PDUs.
Neighbor ID
Indicates the LLDP neighbor number.