Siemens SCALANCE W1750D CLI - Hotspot-H2 Qp-Oper-Name-Profile

CLI Commands
4.8 H
SCALANCE W1750D CLI
140 Function Manual, 03/2019, C79000-G8976-C452-04
4.8.14 hotspot-h2qp-oper-name-profile
Description
This command configures a H2QP operator-friendly name profile.
Syntax
hotspot h2qp-oper-name-profile <profile>
enable
op-fr-name <name>
op-lang-code <language>
no…
Parameter
Description
Range
Default
hotspot h2qp-oper-
name- profile <pro-
file>
Creates an operator-friendly name
profile.
— —
enable
Enables the operator-friendly name
profile.
— —
op-fr-name
<name>
Configures an operator-friendly name
to be sent by devices using this pro-
file. If the name includes quotation
marks (“), include a backslash charac-
ter (\) before each quotation mark.
(e.g. \"example\")
1-64
alphanumeric
characters
—
op-lang-code <lan-
guage>
Configures an ISO 639 language code
that identifies the language used in
the op-fr-name command.
— —
no…
Removes any existing configuration.
—
—
Usage Guidelines
Use this command to configure an operator-friendly name that can identify the operator and
also provides information about the location.
Example
The following example configures an operator friendly profile:
(scalance)(config)# hotspot h2qp-oper-name-profile Profile1
(scalance)(operator-friendly-name "Profile1")# op-fr-name hotspot1
(scalance)(operator-friendly-name "Profile1")# op-lang-code EN
(scalance)(operator-friendly-name "Profile1")# enable
(scalance)(operator-friendly-name "Profile1")# end
(scalance)# commit apply