Siemens SCALANCE W1750D CLI - Page 139

CLI Commands
4.8 H
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
139
Syntax
hotspot h2qp-oper-class-profile <profile>
enable
op-class <class>
no…
Parameter
Description
Range
Default
hotspot h2qp-oper-
class-profile
<profile>
Creates operating class
profile.
— —
enable
Enables the operating
class profile.
— —
op-class <class>
Configures the operat-
ing class for the devic-
es’ BSS.
1-255 1
no…
Removes any existing
configuration.
— —
Usage Guidelines
Use this command to configure values for the H2QP Operating Class profile that lists the
channels on which the hotspot is capable of operating.
Example
The following example configures and enables a profile with the default operating class
value.
(scalance)(config) # hotspot h2qp-oper-class-profile Profile1
(scalance)(operator-class"Profile1")# op-class 1
(scalance)(operator-class"Profile1")# enable
(scalance)(operator-class"Profile1")# end
(scalance)# commit apply
Command Information
AP Platform
Command Mode
All platforms Configuration mode and the H2QP operating
class profile configuration sub-mode