Siemens SCALANCE W1750D CLI - Show Ap Debug Mgmt-Frames

CLI Commands
4.16 S
SCALANCE W1750D CLI
352 Function Manual, 03/2019, C79000-G8976-C452-04
The output of this command includes the following information:
Parameter
Description
Interface
Indicates the LLDP interface name.
LLDP TX
Shows if LLDP PDU transmission is enabled or disabled.
LLDP RX
Shows if the AP has enabled or disabled processing of received LLDP PDUs.
LLDP-MED
Shows if LLDP MED protocol is enabled or disabled.
TX interval
Indicates the LLDP transmit interval in seconds.
Hold Timer
Indicates the LLDP transmit hold multiplier.
Command Information
AP Platform
Command Mode
All platforms
Privileged EXEC mode
4.16.62 show ap debug mgmt-frames
Description
This command displays the trace information for the 802.11 management frames.
Syntax
show ap debug mgmt-frames <mac>
Parameter
Description
<mac>
Displays trace information for an AP based on MAC address.
Example
The following example shows the partial output of show ap debug mgmt-frames command:
Traced 802.11 Management Frames
-------------------------------
Timestamp stype SA DA BSS signal Misc
--------- ----- ------- ------ ----
May 9 23:09:42 deauth d8:c7:c8:c4:29:82 08:ed:b9:e1:51:87 d8:c7:c8:c4:29:82 15 -
May 9 23:09:42 disassoc d8:c7:c8:c4:29:82 08:ed:b9:e1:51:87 d8:c7:c8:c4:29:82 15 -
May 9 23:09:03assoc-respd8:c7:c8:c4:29:82 08:ed:b9:e1:51:87 d8:c7:c8:c4:29:82
15Success
May 9 22:02:40 auth d8:c7:c8:c4:29:8b c4:85:08:de:06:d4 d8:c7:c8:c4:29:8b 15Success