Siemens SCALANCE W1750D CLI - Show Ldap-Servers

CLI Commands
4.16 S
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
527
----------------------
Slave I/f Name Permanent MAC Addr Link Status Member of LAG Link Fail Count
-------------- ------------------ ----------- ------------- ---------------
eth0 6c:f3:7f:c6:76:6e Up Yes 0
eth1 6c:f3:7f:c6:76:6f Up Yes 0
Traffic Sent on Enet Ports
--------------------------
Radio Num
Enet 0 Tx Count
Enet 1 Tx Count
---------
---------------
---------------
0
0
0
1
0
0
non-wifi
2
17
The output of this command displays details such as the link status, number of ports, AP
partner MAC address, and the interface status.
Command Information
AP Platform
Command Mode
AP-220 Series
Privileged EXEC mode
4.16.153 show ldap-servers
Description
This command displays the LDAP servers configured for user authentication on the Virtual
Controller.
Syntax
show radius-servers
Usage Guidelines
Use this command to view the LDAP server configuration information available on an AP.
Example
The following example shows the output of show ldap-servers command:
LDAP Servers
------------
Name IP Address Port Timeout Retry Count Admin-DN Admin Password