Siemens SCALANCE W1750D CLI - Show Port Status

CLI Commands
4.16 S
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
555
Unnumbered dhcp profile dhcpProfile1
show pppoe debug logs
The following example shows the configuration of the PPPoE
show pppoe debug logs
command.
pppd log not available
show pppoe debug status
The following example shows the configuration of the PPPoE
show pppoe debug status
command.
pppoe uplink state :Suppressed.
Command Information
AP Platform
Command Mode
All platforms
Privileged EXEC mode
4.16.188 show port status
Description
Displays the activity statistics on each of the port on the controller.
Syntax
show port status [details]
Example
The following example shows the output of the show port status command:
Port Status
-----------
Port
Type
Admin-State
Oper-State
STP-State
Dot3az
----
----
-----------
----------
---------
------
eth0
GE
up
up
Off
Disable
eth1
GE
up
up
Off
Disable
eth2
GE
up
down
Off
Disable
Loop-Protect
Storm-Control
Loop-Detection-TX
Loop-Detection-RX
------------
-------------
-----------------
-----------------
OFF
OFF
0
1
ON
ON
39153
4
ON
ON
306
4
The output of this command provides the following information:
Parameter
Description