Siemens SCALANCE W1750D CLI - Routing-Profile

CLI Commands
4.15 R
SCALANCE W1750D CLI
236 Function Manual, 03/2019, C79000-G8976-C452-04
(scalance)(RF dot11a Radio Profile)# beacon-interval 100
(scalance)(RF dot11a Radio Profile)# legacy-mode
(scalance)(RF dot11a Radio Profile)# dot11h
(scalance)(RF dot11a Radio Profile)# interference-immunity 3
(scalance)(RF dot11a Radio Profile)# max-tx-power 33
(scalance)(RF dot11a Radio Profile)# min-tx-power 10
(scalance)(RF dot11a Radio Profile)# max-distance 600
(scalance)(RF dot11a Radio Profile)# csa-count 2
(scalance)(RF dot11a Radio Profile)# free-channel-index 40
(scalance)(RF dot11a Radio Profile)# spectrum-monitor
(scalance)(RF dot11a Radio Profile)# end
Command Information
AP Platform
Command Mode
All platforms Configuration mode and RF dot11a Radio Profile
configuration sub-mode
4.15.11 routing-profile
Description
This command configures a routing profile for a specific destination address or destination
subnet.
Syntax
routing-profile
route <destination> <mask> <gateway> {<metric>}
no…
no routing profile
Parameter
Description
routing-profile
<profile>
Creates a routing profile for routing traffic into a specific destination ad-
dress or destination subnet.
route
Configures route parameters.
<destination>
Configures the destination network that is reachable through the VPN
tunnel.
<mask>
Specify the subnet mask of network that is reachable through the VPN
tunnel.