CLI Commands
4.15 R
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
235
free-channel-index
<idx>
The difference in the interference index between
the new channel and current channel must ex-
ceed this value for the AP to move to a new
channel. The higher this value, the lower the
chance an AP will move to the new channel.
10-40 25
Enables the APs to run the radio in non- 802.11n
— Disabled
<count>
When this parameter is set, the radio will still use
the 40 MHz channels even if the 40 MHz intoler-
ance indication is received from another AP or
— Disabled
<power>
Configures the maximum transmit power value
for the 5 GHz radio profile.
3 - max 18 dBm
<power>
Configures the minimum transmit power value for
3 - max 12 dBm
<count>
Configures the maximum distance between a
client and an AP or between a mesh point and a
mesh portal in meters. This value is used to
derive ACK and CTS timeout times.
A value of 0 specifies the default settings for this
parameter, where timeouts are only modified for
outdoor mesh radios which use a distance of
600-1000 0
<type>
Allows you to specify the portion of the channel
to monitor for 5 GHz configuration.
— —
Allows the APs in access mode to continue with
normal access service to clients, while perform-
ing additional function of monitoring RF interfer-
ence (from both neighboring APs and non Wi-Fi
sources such as, microwaves and cordless
phones) on the channel they are currently serv-
— —
throughput-
Disables VHT for clients connecting on the 5
— —
Configures a zone name for the radio profile.
: This parameter cannot be configured on
— —
Removes the configuration.
Usage Guidelines
Use this command to create a 5 GHz radio profile on an AP.
Example
The following example configures the 5 GHz radio profile:
(scalance)(config)# rf dot11a-radio-profile
To Next Page
Loading...
