Siemens SCALANCE W1750D CLI - Show Snmp Trap-Queue

CLI Commands
4.16 S
SCALANCE W1750D CLI
574 Function Manual, 03/2019, C79000-G8976-C452-04
SNMPv3 Users
------------
Name Authentication Type Encryption Type
---- ------------------- ---------------
hallo SHA NONE
DES SHA DES
SNMP Trap Hosts
---------------
IP Address Version Name Port Inform
---------- ------- ---- ---- ------
192.0.2.1 v3 miro 162 Yes
The output of this command includes the following parameters:
Parameter
Description
Engine ID
Displays the SNMP engine ID.
Community Strings
Displays the SNMP community strings.
SNMPv3 Users
Displays details about the SNMPv3 users.
Name
Indicates the name of the SNMP user.
Authentication Type
Indicates the authentication protocol configured for the SNMP users.
Encryption Type
Indicates the encryption type, for example, CBC-DES Symmetric Encryp-
tion Protocol configured for SNMP users.
SNMP Trap Hosts
Displays the traps generated by the host system.
IP Address
Indicates the host IP address generating the SNMP trap.
Version
Displays the SNMP version for which the trap is generated.
Name
Indicates the name of system generating the SNMP traps.
Port
Indicates the port number to which notification messages are sent.
Inform
Displays the SNMP inform messages to send to the configured host.
Command Information
AP Platform
Command Mode
All platforms
Privileged EXEC mode
4.16.201 show snmp trap-queue
Description
This command displays the list of SNMP traps in queue.