Siemens SCALANCE W1750D CLI - Show Dhcp-Allocation

CLI Commands
4.16 S
SCALANCE W1750D CLI
474 Function Manual, 03/2019, C79000-G8976-C452-04
AP-Group contains instant 200 0
Filter-Id contains 123456 200 0
The output of the command provides a list of role and VLAN derivation rules configured for
each SSID and wired profile.
Command Information
AP Platform
Command Mode
All platforms
Privileged EXEC mode
4.16.119 show dhcp-allocation
Description
This command displays information about the DHCP address allocation.
Syntax
show dhcp-allocation
Usage Guidelines
Use this command to view DHCP address allocation for network address translated clients to
allow mobility of the clients across APs.
Example
The following example shows the output of show dhcp-allocation command:
(scalance)# show dhcp-allocation
---------------------/etc/dnsmasq.conf--------------------
listen-address=127.0.0.1
addn-hosts=/etc/ld_eth_hosts addn-hosts=/etc/ld_ppp_hosts dhcp-src=192.168.10.1
dhcp-leasefile=/tmp/dnsmasq.leases dhcp-authoritative
filterwin2k
#magic-vlan
{
vlan-id=3333
dhcp-range=192.168.10.3,192.168.11.254,255.255.254.0,12h