Siemens SCALANCE W1750D CLI - Show Spectum-Alert

CLI Commands
4.16 S
SCALANCE W1750D CLI
576 Function Manual, 03/2019, C79000-G8976-C452-04
SSH Ciphers Settings:
Ciphers :aes128-ctr,aes192-ctr,aes256-ctr,aes128-cbc,aes192-cbc,aes256-cbc
Command Information
AP Platform
Command Mode
All platforms
Privileged EXEC mode
4.16.203 show spectum-alert
Description
This command displays the list of spectrum alerts for an AP.
Syntax
show spectrum-alert
Parameter
Description
<count>
Filters the alerts based on the specified number.
Usage Guidelines
Use this command to view the spectrum alerts for an AP. When a new non Wi-Fi device is
found, an alert is reported to the Virtual Controller. The spectrum alert messages provide
information about the device ID, device type, IP address of the spectrum monitor or hybrid
AP, and the timestamp. The Virtual Controller reports the detailed device information to
AirWave Management server.
Example
The following example shows the output for the show spectrum-alert command when no
alerts are generated.
Spectrum Alerts
---------------
Timestamp Type ID Access Point
--------- ---- -- ------------
The output of this command provides the following information:
Parameter
Description
Timestamp
Displays the time at which alert was recorded.
Type
Displays the type of the device that generated the alert.