Siemens SCALANCE W1750D CLI - Show Log Network

CLI Commands
4.16 S
SCALANCE W1750D CLI
534 Function Manual, 03/2019, C79000-G8976-C452-04
vlan 0, 1 tid 255 oldapip 0.0.0.0 fapip 10.17.88.59 hapip 0.0.0.0 vcip 0.0.0.0 info
l2-timed-out,test
The output of this command provides the following information:
Content
Description
Timestamp
Indicates the timestamp of the L3 mobility event.
Client MAC
Indicates the MAC address of the roaming clients.
Event
Provides a description of the mobility event.
Home Vlan
Displays the VLAN ID associated with the home subnet.
VAP Vlan
Displays the VLAN ID associated with the Virtua AP.
tid
Indicates the tunnel interface used for routing packets.
Old AP IP
Indicates the IP address of the AP from which the client has roamed.
FAP IP
Indicates the IP address of the AP in the foreign subnet.
HAP IP
Indicates the IP address of the AP in the home subnet, to which the client is
currently connected.
VC IP
Indicates the IP address of the Virtual Controller.
Additional Info
Displays additional information if any.
Command Information
AP Platform
Command Mode
All platforms
Privileged EXEC mode
4.16.162 show log network
Description
This command shows network logs for the AP.
Syntax
show log network <count>
Parameter
Description
<count>
Starts displaying the log output from the specified number of lines from
the end of the log.
Command Information
AP Platform
Command Mode
All platforms
Privileged EXEC mode