Siemens SCALANCE W1750D CLI - Show Ids-Protection Config

CLI Commands
4.16 S
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
509
4.16.140 show ids-protection config
Description
This command displays the list of infrastructure protection policies for an AP.
Syntax
show ids-protection config
Usage Guidelines
Use this command to view the status of infrastructure protection policies on an AP.
Example
The following output is displayed for the show ids-protection config command:
Wireless Containment :none
Wired Containment :off
infrastructure protection level :off
---------------------------------------------------
Policies Status Low High
-------- ------ --- ----
protect-ssid disable enable enable
rogue-containment disable enable enable protect-adhoc-
network disable disable enable
protect-ap-impersonation disable disable enable
client protection level :off
---------------------------------------------------
Policies Status Low High
-------- ------ --- ----
protect-valid-sta disable enable enable protect-windows-
bridge disable disable enable
Parameter
Description
Infrastructure protection lev-
el
Indicates if the protection level for the policies is set to off, low,
medium, or high.
Policies
Displays the list of wired and wireless network infrastructure
protection policies.
Status
Indicates if a policy is enabled or disabled.
Low
Indicates if the protection level for a policy is set to low.