CLI Commands
4.16 S
SCALANCE W1750D CLI
348 Function Manual, 03/2019, C79000-G8976-C452-04
4.16.59 show ap debug lldp
Description
This command displays LLDP counters for a specific AP, or all APs sending or receiving
LLDP PDUs.
Syntax
show ap debug lldp {counters | neighbor [interface <name> detail] | state}
Displays LLDP counters for a specific AP, or all APs sending or receiving
The LLDP protocol allows switches, routers, and WLAN access points to
advertise information about themselves such as identity, capabilities, and
neighbors to other nodes on the network. Use this command to display
information about LLDP peers and APs. By default, this command dis-
plays LLDP neighbors for the entire list of LLDP interfaces. Include the IP
address of an to display neighbor information only for that one device.
Displays the name of the AP interface sending or receiving LLDP PDUs.
Displays details about the interface and number of neighbors.
This command displays the LLDP interfaces information sending or
Example
The following example shows the output of show ap debug lldp counters command.
(scalance)# show ap debug lldp counters
The output of this command includes the following information:
The following example shows the output of
show ap debug lldp counters command:
Name of the AP interface sending or receiving LLDP PDUs.
Number of packets received on the specified interface.
Number of LLDP PDUs with an unknown TLV.
Number of malformed packets received on that interface.
Number of times that an LLDP neighbor could not be added to the neighbor table
(there is a limit of 8 per port).
Number of packets transmitted from that interface.
The following example shows the output of show ap debug lldp neighbor command.
To Next Page
Loading...
