Siemens SCALANCE W1750D CLI - Restrict-Mgmt-Access

CLI Commands
4.15 R
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
225
Usage Guidelines
Use this command to configure restricted corporate to block unauthorized users from
accessing the corporate network. When restricted corporate access is enabled, corporate
access is blocked from the uplink port of master AP, including clients connected to a slave
AP.
Example
The following example enables restricted access to the corporate network;
(scalance)(config) # restrict-corp-access
(scalance)(config) # end
(scalance)# commit apply
Command Information
All platforms
Configuration mode
All platforms
Privileged EXEC mode
4.15.6 restrict-mgmt-access
Description
This command configures management subnet on an AP.
Syntax
restricted-mgmt-access <subnet> <mask>
no…
Parameter
Description
subnet
Configures a management subnet address.
mask
Configures the subnet mask for the management subnet address.
no…
Removes the configuration.
Usage Guidelines
Use this command to configure management subnets. This ensures that the AP
management is carried out only from these subnets. When the management subnets are
configured, Telnet, SSH, and UI access is restricted to these subnets only.