Siemens SCALANCE W1750D CLI - Show Uplink-Vlan

CLI Commands
4.16 S
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
601
Continuous pkt lost :0
VPN down time :0
The output of this command provides the following information:
Column
Description
Uplink preemption
Indicates if the uplink preemption is enabled.
Uplink enforce
Indicates if any uplinks are enforced.
Ethernet uplink eth0
Indicates if Ethernet uplink is configured.
Type
Indicates the type of the uplink.
State
Indicates the uplink status.
Priority
Indicates if any priority levels are assigned to the
uplink.
In Use
Indicates if the uplink is in use.
Max allowed test packet loss
Indicates an allowed number of test packets that
can be lost verifying the Internet availability.
Secs between test packets
Indicates the frequency at which the test packets
are sent to verify the Internet availability.
VPN failover timeout (secs)
Indicates the number of seconds to wait, before
trying a different uplink when a VPN tunnel is
down.
ICMP pkt sent
Indicates the number of ICMP packets sent to
verify the Internet availability for uplink switch-
over.
ICMP pkt lost
Indicates the number of ICMP packets lost.
Continuous pkt lost
Indicates if the packets are lost continuously.
VPN down time
Indicates the time since the VPN connection is
unavailable.
Command Information
AP Platform
Command Mode
All platforms
Privileged EXEC mode
4.16.220 show uplink-vlan
Description
This command displays the uplink VLAN configuration details for the management traffic.
Syntax
show uplink-vlan