CLI Commands
4.16 S
SCALANCE W1750D CLI
600 Function Manual, 03/2019, C79000-G8976-C452-04
Example
The following output is displayed for the show uplink config command:
Uplink preemption :enable
Uplink enforce :none
Ethernet uplink eth0 :DHCP
Internet failover :disable
Max allowed test packet loss:10
Secs between test packets :30
VPN failover timeout (secs) :180
The output of this command provides the following information:
Indicates if the uplink preemption is enabled.
Indicates if any uplinks are enforced.
Indicates if Ethernet uplink is configured.
Max allowed test packet loss
Indicates an allowed number of test packets that can be lost
verifying the Internet availability.
Secs between test packets
Indicates the frequency at which the test packets are sent to
verify the Internet availability.
VPN failover timeout (secs)
Indicates the number of seconds to wait, before trying a differ-
ent uplink when a VPN tunnel is down.
The following output is displayed for the show uplink status command:
Uplink preemption :enable
Uplink enforce :none
Ethernet uplink eth0 :DHCP
Uplink Table
------------
Type State Priority In Use
---- ----- -------- ------
eth0 UP 0 Yes
Wifi-sta INIT 6 No
3G/4G INIT 7 No
Internet failover :disable
Max allowed test packet loss:10
Secs between test packets :30
VPN failover timeout (secs) :180
ICMP pkt sent :0
ICMP pkt lost :0
To Next Page