Siemens SCALANCE W1750D CLI - Show Aps

CLI Commands
4.16 S
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
395
Command Information
AP Platform
Command Mode
All platforms
Privileged EXEC mode
4.16.88 show aps
Description
This command displays all active APs, AP scanning, and AP synchronization status.
Syntax
show aps [scanning][power-monitor][sync]
Parameter
Description
aps
Displays the list of all active APs in the cluster.
aps scanning
Displays AP scanning details.
power-monitor
Displays the power consumption information of an AP.
aps sync
Displays AP synchronization details.
Usage Guidelines
Use this command to view the list of active APs, AP scanning and synchronization details.
Example
The following output is displayed for the show aps command:
c8:b5:ad:c3:ac:5c# show aps
1 Access Point
--------------
Name IP Address Mode Spectrum Clients Type IPv6 Address
Mesh Role Zone Serial # 2.4 Channel 2.4 Power (dB) 2.4 Utilization (%) 2.4
Noise Floor (dBm) 5.0 Channel 5.0 Power (dB) 5.0 Utilization (%) 5.0 Noise Floor
(dBm) Need Antenna Config From Port Config Id Config Csum Ext SSID Active Age Link
Local IP Address
---- ---------- ---- -------- ------- ---- ------------
--------- ---- -------- ----------- -------------- ------------------- --------
------------- ----------- -------------- ------------------- --------------------- --
----
------------- --------- --------- ----------- --------------- --- --------------