Siemens SCALANCE W1750D CLI - Page 396

CLI Commands
4.16 S
SCALANCE W1750D CLI
396 Function Manual, 03/2019, C79000-G8976-C452-04
-------
c8:b5:ad:c3:ac:5c 192.168.1.128* access disable 1 345(indoor)
fe80::cab5:adff:fec3:ac5c N/A - CNDBK5106R 149E 19 51(ok)
-90(good) 52E 12 51(ok) -88(good)
No none 0 12495 enable
20h:22m:48s fe80::cab5:adff:fec3:ac5c
The output of this command includes the following parameters:
Column
Description
Name
Name of the APs.
IP address
IP address of the APs.
Mode
Operating mode. For example, access, monitor, or spectrum monitor modes.
Spectrum
Indicates if spectrum monitoring is enabled or disabled.
Client
Indicates the number of client associated with the AP.
Type
Displays the AP model.
IPv6 address
IPv6 address of the AP
Mesh Role
Indicates if the AP is functioning as Mesh Point or mesh Portal.
Zone
Zone name of the AP.
Serial
Serial number of the AP.
2.4 Channel
Channels used by the AP in the 2.4 GHz band.
2.4 Power(dB)
Transmission power allocated for 2.4 Ghz band channels.
2.4 Utilization
Percentage of utilization of 2.4 GHz channels.
2.4 Noise Floor
Noise floor of the 2.4 GHz channels.
5.0 Channel
Channels used by the AP in the 5 GHz band.
5.0 Power(dB)
Transmission power allocated for 5 GHz band channels.
5.0 Utilization
Percentage of utilization of 5 GHz channels.
5.0 Noise Floor
Noise floor of the 5 GHz channels.
Need antenna con-
fig
Indicates if antenna configuration is required.
From port
Indicates the port details if any.
Config Id
Indicates the configuration ID.
Config Csum
Checksum that is used for configuration sync between master and slave-
access points.
Ext SSID Active
Extended SSID flag that indicates if mesh is enabled.
Age
Active time of the current master AP.
Link Local IP
Address
IPv6 link local IP address of the AP.
The following output is displayed for the show aps scanning command:
AP Scanning Stats
-----------------
Name IP Address 2.4 Reqs 2.4 Voice Rejs 2.4 Video Rejs 5.0 Reqs
---- ---------- -------- -------------- -------------- -----