Siemens SCALANCE W1750D CLI - Page 397

CLI Commands
4.16 S
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
397
d8:c7:c8:cb:d4:20 10.17.88.188 5665 0 0 5675
5.0 Voice Rejs 5.0 Video Rejs
-------------- --------------
0 0
The output of this command includes the following parameters:
Column
Description
IP address
Displays the Name of the AP.
2.4 Reqs
5.0 Reqs
Displays the IP address of the AP.
2.4 Voice Rejs
5.0 Voice Rejs
Displays the counters that indicate the number of scanning rejects due to
voice traffic.
2.4 Voice Rejs
5.0 Voice Rejs
Displays the counters that indicate the number of scanning rejects due to
voice traffic.
The following example shows the output of show aps power-monitor command:
(scalance)# show aps power-monitor
AP Power Monitoring information
-------------------------------
Name
IP Address
Current(mW)
Average(mW)
Minimum(mW)
Maximum(mW)
----
----------
-----------
-----------
-----------
-----------
70:3a:0e:cc:ef:02
10.65.72.14
11564
11569
11516
11840
70:3a:0e:cc:ec:b8
10.65.72.13
11603
11581
11488
12286
The output of this command includes the following information:
Column
Description
Name
Host name of the AP.
IP Address
IP Address of the AP.
Current(mW)
The current power consumption value, in mW.
Average(mW)
The average power consumption value of APs sampled over the previous
one minute, in mW.
Minimum(mW)
The minimum power consumption value of APs sampled over the previous
one minute, in mW.
Maximum(mW)
The maximum power consumption value of APs sampled over the previous
one minute, in mW.
The following output is displayed for the show aps sync command:
AP Sync List
------------
MAC IP Address Class Current Version
--- ---------- ----- ---------------