Siemens SCALANCE W1750D CLI - Vpn Hold-Time

CLI Commands
4.19 V
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
655
Command Information
AP Platform
Command Mode
All platforms
Configuration mode
4.19.8 vpn hold-time
Description
This command configures the time interval after which the AP can switch over to the primary
host when preemption is enabled.
Syntax
vpn hold-time <seconds>
no...
Parameter
Description
vpn hold-time <sec-
onds>
Configures a time period in seconds after which the APs can switch to
primary VPN server.
no…
Removes the configuration.
Usage Guidelines
Use this command to configure a period to hold on switching to the primary server when pre-
emption is enabled.
Example
The following example configures a hold-time to switch to the primary host server:
(scalance)(config)# hold-time <seconds>
(scalance)(config)# end
(scalance)# commit apply
Command Information
AP Platform
Command Mode
All platforms
Configuration mode