SCALANCE W CLI
3.1 Saving Configuration Changes
SCALANCE W1750D CLI
22 Function Manual, 03/2019, C79000-G8976-C452-04
3.1 Saving Configuration Changes
The
running-config
holds the current AP configuration, including all pending changes which
are yet to be saved. To view the running-config of an AP, use the following command:
(scalance) # show running-config
When you make configuration changes through the CLI, the changes affect the current
running configuration only. To save your configuration changes, use the following command
in the privileged Exec mode:
(scalance)# write memory
Commands that Reset the AP
If you use the CLI to modify a currently provisioned radio profile, the changes take place
immediately. A reboot of the AP is not required to apply the configuration changes. Certain
commands, however, automatically force AP to reboot. Verify the current network loads and
conditions before executing the commands that enforce a reboot of the AP, as they may
cause a momentary disruption in service as the unit resets.
The
reload command resets an AP.
To Next Page
Loading...
