Siemens SCALANCE W1750D CLI - Firewall

CLI Commands
4.6 F
SCALANCE W1750D CLI
110 Function Manual, 03/2019, C79000-G8976-C452-04
Usage Guidelines
Use this command to reset an AP to use the factory default SSID.
Example
The following example enables factory default configuration:
(scalance)(config)# factory-ssid-enable
(scalance)(config)# end
(scalance)# commit apply
Command Information
AP Platform
Command Mode
All platforms
Configuration mode
4.6.3 firewall
Description
This command allows control over the ACEs that are automatically programmed due to
expansion of the ACLs.
Syntax
firewall
disable-auto-topology-rules
no…
Parameter
Description
firewall
Opens the firewall configuration mode.
disable-auto-topology-rules
Disables the default auto topology rule that is created for prede-
fined ACLs and WLAN Access Rules.
no…
Removes the specified configuration parameter.
Usage Guidelines
Use this command to remove the default auto topology rules created for predefined ACLs
and WLAN Access Rules. When
disable-auto-topology-rules is configured on the AP and the
Inbound Firewall rule is set using the Scalance W UI, the user rules take precedence over
the guest VLAN ACL expansion and overrides the auto-expanded rules. However, the
corporate and local VLAN expansions will continue to take precedence over the user rules.