Siemens SCALANCE W1750D CLI - Show Ip Igmp

CLI Commands
4.16 S
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
515
Usage Guidelines
Use this command to the DHCP server settings. The DHCP server is a built-in server, used
for networks in which clients are assigned IP address by the Virtual Controller.
Example
The following output is displayed for the show ip dhcp database command:
DHCP Subnet :192.0.2.0
DHCP Netmask :255.255.255.0
DHCP Domain Name :example.com
DHCP DNS Server :192.0.2.1
DHCP DNS Cache :Disabled
The output of this command provides the following information:
Column
Description
DHCP subnet
Indicates the network range for the client IP addresses.
DHCP Netmask
Indicates the subnet mask specified for the IP address range for the DHCP
subnet.
DHCP Lease Time (m)
Indicates the duration of DHCP lease. The lease time refers to the duration
of lease that a DHCP-enabled client has obtained for an IP address from a
DHCP server.
DHCP Domain Name
Indicates the domain-name of the DHCP client.
DHCP DNS Server
Indicates the IP address of the DNS server.
DHCP DNS Cache
Indicates if the DNS cache is enabled.
Command Information
AP Platform
Command Mode
All platforms
Privileged EXEC mode
4.16.146 show ip igmp
Description
This command displays information about the Internet Group Management Protocol (IGMP)
group table.