Siemens SCALANCE W1750D CLI - Proxy

CLI Commands
4.14 P
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
219
Example
The following example configures the PPPoE uplink on an AP:
(scalance)(config) # pppoe-uplink-profile
(scalance)(pppoe-uplink-profile)# pppoe-username User1
(scalance)(pppoe-uplink-profile)# pppoe-passwd Password123
(scalance)(pppoe-uplink-profile)# pppoe-svcname internet03
(scalance)(pppoe-uplink-profile)# pppoe-chapsecret 8e87644deda9364100719e017f88ebce
(scalance)(pppoe-uplink-profile)# pppoe-unnumbered-local-l3-dhcp-profile dhcpProfile1
(scalance)(pppoe-uplink-profile)# end
(scalance)# commit apply
Command Information
AP Platform
Command Mode
All platforms Configuration mode and PPPoE uplink profile
configuration sub- mode.
4.14.9 proxy
Description
This command configures HTTP proxy settings.
Syntax
proxy {exception <host>| server <host> <port> [<username> <password>]}
Parameter
Description
exception
<hostname>
Sets the IP address or the domain name of the host to be added under
the exception list.
server <hostname>
<port number>
[<username> <pass-
word>]
Sets the HTTP proxy server's IP address or domain name and the port
number. You can optionally configure a username and password to
authenticate the proxy server.
NOTE:
The username and password options are applicable only to con-
figure proxy support for web classification.
Usage Guidelines
This command configures the HTTP proxy settings in an AP to download the image from the
cloud server. This command also configures the HTTP proxy settings in an AP to route the
web classification queries through the proxy server.