Siemens SCALANCE W1750D CLI - Lacp-Mode

CLI Commands
4.10 L
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
191
Usage Guidelines
Use this command to configure layer-3 mobility domains on an AP.
Example
The following example configures L3-mobility:
(scalance)(config)# l3-mobility
(scalance)(L3-mobility)# home-agent-load-balancing
(scalance)(L3-mobility)# virtual-controller 192.0.2.1
(scalance)(L3-mobility)# subnet 192.0.2.2 255.255.255.0 1 192.0.2.1
(scalance)(L3-mobility)# end
(scalance)# commit apply
Command Information
AP Platform
Command Mode
All platforms Configuration mode and L3 mobility configuration
sub-mode.
4.10.2 lacp-mode
Description
This command is introduced to support the static LACP configuration.
Syntax
lacp-mode {enable|disable}
no..
Parameter
Description
enable
This parameter enables the static LACP configuration. The AP will work
on LACP mode irrespective of whether or not the peer switch works on
the LACP mode.
disable
This parameter disables the static LACP configuration. The AP will not
work on LACP mode even it detects any LACP PDUs from the peer
switch.
no
Removes the static LACP configuration