Siemens SCALANCE W1750D CLI - Show Blacklist-Client

CLI Commands
4.16 S
SCALANCE W1750D CLI
412 Function Manual, 03/2019, C79000-G8976-C452-04
4.16.98 show blacklist-client
Description
This command shows the configuration details for blacklisting clients and lists the clients
blacklisted by an AP.
Syntax
show blacklist-client [config]
Parameter
Description
config
Displays the parameters and values configured for manual or dynamic
blacklisting of clients.
Usage Guidelines
Use this command to view information about the clients blacklisted by an AP.
Example
The following output is displayed for the show blacklist-client command:
Blacklisted Clients
-------------------
MAC Reason Timestamp Remaining time(sec) AP name
--- ------ --------- ------------------- -------
00:24:6c:ca:41:51 user-defined 14:46:18 Permanent -
The output of this command provides information on the MAC address of client that is
blacklisted, the reason for blacklisting, timestamp, the associated AP name, and the duration
until which the client is blacklisted.
The following output is displayed for the
show blacklist-client config command:
Blacklist Time :3600
Auth Failure Blacklist Time :3600
Manually Blacklisted Clients
----------------------------
MAC Time
--- ----
00:24:6c:ca:41:51 14:46:18
Dynamically Blacklisted Clients
-------------------------------
MAC Reason Timestamp Remaining time(sec) AP name