Siemens SCALANCE W1750D CLI - Clock Timezone; Cluster-Security

CLI Commands
4.3 C
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
75
4.3.10 clock timezone
Description
This command sets the timezone on an AP.
Syntax
clock timezone <name> <hour-offset> <minute-offset>
no…
Parameter
Description
Range
clock timezone
<name>
Configures the required timezone. All supported timezones
<hour-offset>
Specifies the hours offset from the UTC.
—
<minute-offset>
Specifies the hours offset from the UTC.
—
no…
Removes the timezone configuration.
—
Usage Guidelines
Use this command to set the timezone on an AP.
Example
The following example configures the PST timezone:
(scalance) (config)# clock timezone PST -8 0
(scalance)(config)# end
(scalance)# commit apply
Command Information
AP Platform
Command Mode
All platforms
Configuration mode
4.3.11 cluster-security
Description
This command enables cluster security in DTLS mode and also provides an option for users
to allow or deny a DTLS connection for low assurance APs.