Siemens SCALANCE W1750D CLI - Calea

CLI Commands
4.3 C
SCALANCE W1750D CLI
64 Function Manual, 03/2019, C79000-G8976-C452-04
4.3 C
4.3.1 calea
Description
This command creates a CALEA profile to enable APs for LI compliance and CALEA
integration.
Syntax
calea
encapsulation-type <gre>
gre-type <type>
ip <IP-address>
ip mtu <size>
no…
no calea
Parameter
Description
Range
Default
calea
Enables
calea
configuration sub-mode for CALEA
profile configuration.
— —
gre-type
Specifies GRE type.
—
25944
encapsulation-type
<gre>
Specifies the encapsulation type for Generic
Routing Encapsulation (GRE) packets.
GRE GRE
ip <IP-address>
Configures the IP address of the CALEA server
on an AP.
— —
ip mtu <size>
Configures the Maximum Transmission Unit size
to use.
68—
1500
1500
no…
Disables the parameters configured under the
calea command.
— —
no calea
Removes the CALEA configuration
—
—
Usage Guidelines
Use this command to configure an AP to support LI. LI allows the LEA to conduct an
authorized electronic surveillance. Depending on the country of operation, the service
providers are required to support LI in their respective networks.
In the United States, SPs are required to ensure LI compliance based on CALEA
specifications. LI compliance in the United States is specified by the CALEA.
For more information on configuringAPs for CALEA integration, see
Configuration Manual
"SCALANCE W UI"
.