Siemens SCALANCE W1750D CLI - Vpn Reconnect-User-On-Failover

CLI Commands
4.19 V
SCALANCE W1750D CLI
658 Function Manual, 03/2019, C79000-G8976-C452-04
Usage Guidelines
Use this command to monitor VPN connections and verify its availability at regular intervals.
Example
The following example configures the VPN monitoring frequency:
(scalance)(config)# vpn monitor-pkt-send-freq 10
(scalance)(config)# end
(scalance)# commit apply
Command Information
AP Platform
Command Mode
All platforms
Configuration mode
4.19.12 vpn reconnect-user-on-failover
Description
This command enables the users to reconnect to the VPN when the primary VPN tunnel
fails.
Syntax
vpn reconnect-user-on-failover
no…
Parameter
Description
vpn reconnect-user-on-
failover
Enables users to reconnect to the VPN during a VPN failover.
no…
Removes the configuration.
Usage Guidelines
Use this command to allow the users to reconnect to the VPN after a VPN failover. When
enabled , the AP reconnects the user during a VPN failover.
Example
The following example enables users to reconnect to VPN after a failover:
(scalance)(config)# vpn reconnect-user-on-failover
(scalance)(config)# end