Siemens SCALANCE W1750D CLI - Show Ap Mesh Link

CLI Commands
4.16 S
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
373
Parameter
Description
Probe Resp
Number of probe response packets sent to the interface specified in the
Interface parameter.
Assoc Req
Number of association request packets from the interface specified in the
Interface parameter.
Assoc Resp
Number of association response packets from the interface specified in the
Interface parameter. This number includes valid responses and fail re-
sponses.
Assoc Fail
Number of fail responses received from the interface specified in the Inter-
face parameter.
Link up/down
Number of times the link up or link down state has changed.
Resel.
Number of times a mesh point attempted to reselect a different mesh portal.
Switch
Number of times a mesh point successfully switched to a different mesh
portal.
Other Mgmt
Management frames of any type other than association and probe frames,
either received on child interface, or sent on parent interface.
Command Information
AP Platform
Command Mode
All platforms
Privileged EXEC mode
4.16.79 show ap mesh link
Description
This command shows the mesh link of the AP.
Syntax
show ap mesh link
Example
The following example shows the output of show ap mesh link command:
(scalance)# show ap mesh link Neighbor list
-------------
MAC Portal Channel Age Hops Cost Relation Flags RSSI Rate Tx/Rx
--- ------ ------- --- ---- ---- -------- ----- ---- ----------
00:0b:86:e8:09:d1 00:1a:1e:88:01:f0 157 0 1 11.00 C 3h:15m:42s - 65
54/54
00:1a:1e:88:02:91 00:1a:1e:88:01:f0 157 0 1 4.00 C 3h:35m:30s HL 59