Siemens SCALANCE W1750D CLI - Page 21

SCALANCE W CLI
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
21
Deleting Configuration Settings
Use the no command to delete or negate previously-entered configurations or parameters.
● To view a list of no commands, type
no at the prompt in the relevant mode or sub-mode
followed by the question mark. For example:
(scalance)(config) # no?
● To delete a configuration, use the
no form of a configuration command. For example, the
following command removes a configured user role:
(scalance)(config) # no user <username>
● To negate a specific configured parameter, use the
no parameter within the command.
For example, the following command deletes the PPPoE user configuration settings:
(scalance)(config) # pppoe-uplink-profile
(scalance)(pppoe_uplink_profile)# no pppoe-username
Using Sequence Sensitive Commands
The SCALANcE W CLI does not support positioning or precedence of sequence-sensitive
commands. Therefore, Siemens recommends that you remove the existing configuration
before adding or modifying the configuration details for sequence-sensitive commands. You
can either delete an existing profile or remove a specific configuration by using the
no…
commands.
The following table lists the sequence-sensitive commands and the corresponding
no
command to remove the configuration.
Table 3- 1 Sequence-Sensitive Commands
Sequence-Sensitive Command
Corresponding no command
opendns <username> <password>
no opendns
rule <dest> <mask> <match> <protocol>
<start-port> <end-port> {permit |deny |
src-nat | dst-nat {<IPaddress> <port>|
<port>}}[<option1…option9>]
no rule <dest> <:mask> <match> <protocol>
<start-port> <end-port> {permit | deny |
src-nat | dst-nat}
mgmt-auth-server <auth-profile-name>
no mgmt-auth-server <auth-profilename>
set-role <attribute>{{equals| not-equals|
startswith| ends-with| contains} <opera-
tor> <role>| valueof}
no set-role <attribute>{{equals| not-
equals| starts-with| ends-
with| contains}
<operator>| value-of}
no set-role
set-vlan <attribute>{{equals| not-equals|
startswith| ends-with| contains} <opera-
tor> <VLAN-ID>| value-of}
no set-vlan <attribute>{{equals| not-
equals| starts-with| ends-
with| contains}
<operator>| value-of}
no set-vlan
auth-server <name>
no auth-server <name>