Siemens SCALANCE W1750D CLI - Page 146

CLI Commands
4.8 H
SCALANCE W1750D CLI
146 Function Manual, 03/2019, C79000-G8976-C452-04
Parameter
Description
Range
Default
downlink-speed
<speed>
Indicates the current WAN backhaul
downlink speed in Kbps. If no value is
set, this parameter will show a default
value of 0 to indicate that the downlink
speed is unknown or unspecified.
0 -
2,147,483,647
0
(unspecified)
enable
Enables the H2QP WAN metrics pro-
file.
— —
load-duration
<duration>
Configures a duration at which the
downlink load is measured, in tenths of
a second.
0 and 65535 —
symm-link
Indicates that the WAN Link has same
speed in both the uplink and downlink
directions.
— —
no
Removes any existing configuration.
—
—
uplink-load <speed>
The percentage of the WAN uplink that
is currently utilized. If no value is set,
this parameter will show adefault value
of 0 to indicate thatthe downlink speed
is unknown or unspecified.
1-100 0
(unspecified)
uplink-spead
<speed>
Use the
uplink <speed>
parameter to
indicate the current WAN backhaul
uplink speed in Kbps.If no value is set,
this parameter will show a default
value of 0 to indicate that the uplink
speed is unknown or unspecified.
0 -
2,147,483,647
kbps
0
(unspecified)
wan-metrics-link-
status
Define the status of the WAN Link by
configuring one of the following values.
— —
<status>
Configures any of the following states:
•
link-up
— Indicates if WAN link is
up.
•
link-down
— Indicates if WAN link is
down
•
link-under-test
—Indicates if WAN
link is currently in a test state.
link-down, link-
under- test, link-
up
unspecified
Usage Guidelines
Use this command to configure the values be sent in an H2QP IE to provide information
about access network characteristics such as link status and the capacity and speed of the
WAN link to the Internet.
Example
The following example configures a WAN metric profile:
(scalance)(config)# hotspot h2qp-wan-metrics-profile Wan1
(scalance)(WAN-metrics "Wan1")# at-capacity
(scalance)(WAN-metrics "Wan1")# downlink-load 5