Siemens SCALANCE W1750D CLI - Page 125

CLI Commands
4.8 H
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
125
Parameter
Description
ipv4-addr-avail
Indicates the availability of an IPv4 network. It can take one of the
following values:
• public
• port-restricted single-nated- private
• double-nated- private
• port-restricted- single-nated- private
• port-restricted- double-nated- private
• not-available
ipv6-addr-avail
Indicates the availability of an IPv6 network. This can take one of the
following values:
• available
• not-available
no…
Removes the existing configuration.
Usage Guidelines
Use this command to configure the IP Address availability information and IP address types
which could be allocated to the clients after they associate to the hotspot AP.
Example
The following command configures an AP using this profile to advertise a public IPv4
network.
(scalance)(config)# hotspot anqp-ip-addr-avail-profile default
(scalance)(IP-addr-avail "default")# ipv4-addr-avail
(scalance)(IP-addr-avail "default")# ipv6-addr-avail
(scalance)(IP-addr-avail "default")# enable
(scalance)(IP-addr-avail "default")# end
(scalance)# commit apply
Command Information
AP Platform
Command Mode
All platforms Configuration mode and the ANQP IP address
availability profile configuration sub-mode