CLI Commands
4.18 U
SCALANCE W1750D CLI
646 Function Manual, 03/2019, C79000-G8976-C452-04
Syntax
user <username> [<password>] [portal| radius]
no…
Creates a username for the AP user.
Assigns a password for the AP user
Configures an employee user
Removes the configuration
Usage Guidelines
The Scalance W user database consists of a list of guest and employee users. Addition of a
user involves specifying a login credentials for a user. The login credentials for these users
are provided outside the Scalance W system.
A guest user can be a visitor who is temporarily using the enterprise network to access the
Internet. However, if you do not want to allow access to the internal network and the Intranet,
you can segregate the guest traffic from the enterprise traffic by creating a guest WLAN and
specifying the required authentication, encryption, and access rules.
An employee user is the employee who is using the enterprise network for official tasks. You
can create Employee WLANs, specify the required authentication, encryption and access
rules and allow the employees to use the enterprise network.
The user database is also used when an AP is configured as an internal RADIUS server.
The local user database of APs can support up to 512 user entries except AP-9x supports
only 256 user entries. If there are already 512 users, AP-9x will not be able to join the
cluster.
Example
The following example configures an employee user for an AP:
(scalance)(config)# user user1 password123 radius
(scalance)(config)# end
(scalance)# commit apply
Command Information
To Next Page
Loading...
