Siemens SCALANCE W1750D CLI - Page 610

CLI Commands
4.16 S
SCALANCE W1750D CLI
610 Function Manual, 03/2019, C79000-G8976-C452-04
● vpn hold-time
● vpn monitor-pkt-lost-cnt
● vpn monitor-pkt-send-freq
● vpn ikepsk
● gre type
● gre primary
● gre per-ap-tunnel
The following example shows the output displayed for
show vpn status command:
profile name:default
--------------------------------------------------
current using tunnel :unselected tunnel
ipsec is preempt status :disable
ipsec is fast failover status :disable
ipsec hold on period 600
ipsec tunnel monitor frequency (seconds/packet) 5
ipsec tunnel monitor timeout by lost packet cnt 2
ipsec primary tunnel crypto type :Cert
ipsec primary tunnel peer address :N/A
ipsec primary tunnel peer tunnel ip :N/A
ipsec primary tunnel ap tunnel ip :N/A
ipsec primary tunnel current sm status :Init
ipsec primary tunnel tunnel status :Down
ipsec primary tunnel tunnel retry times 0
ipsec primary tunnel tunnel uptime 0
ipsec backup tunnel crypto type :Cert
ipsec backup tunnel peer address :N/A
ipsec backup tunnel peer tunnel ip :N/A
ipsec backup tunnel ap tunnel ip :N/A
ipsec backup tunnel current sm status :Init
ipsec backup tunnel tunnel status :Down
ipsec backup tunnel tunnel retry times 0
ipsec backup tunnel tunnel uptime 0
The
show vpn status command displays the current status of VPN connection, IP address
configured for VPN/IPSec connections, and the tunnel details.