CLI Commands
4.16 S
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
385
Current Scan Channel 153-
Current Channel Index 9
Current Scan Start Milli Tick 232927000
Current Dwell Time 110
Current Scan Type active Scan-
Type-Info
---------------
Info-Type Active Reg-domain All-reg-domain Rare DOS
--------- ------ ---------- -------------- ---- ---
Dwell Times 500 250 200 100 500
Last Scan Channel 153- 44+ 0 0 0
show ap monitor state
The following example shows the output of
show ap monitor state command.
DoS State
----------
tx old-tx rx old-rx last-dos-time ap-ev-time sta-ev-time last-enhanced-cm-time
enhanced-cm-ev- time
-- ------ -- ------ ------------- ---------- ----------- --------------------- ------
---------
----
0 0 0 0 0 0 0 0 0
show ap monitor stats
The following example shows the output of
show ap monitor stats command.
(scalance)# show ap monitor stats d8:c7:c8:cb:d4:22 Aggregate Stats
---------------
retry low-speed non-unicast recv-error frag bwidth
----- --------- ----------- ---------- ---- ------
0 0 0 0 0 0
RSSI
----
avg-signal low-signal high-signal count duration (sec)
---------- ---------- ----------- ----- --------------
40 40 40 748 70
AP Impersonation State
To Next Page