Siemens SCALANCE W1750D CLI - Page 463

CLI Commands
4.16 S
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
463
The following example shows the output of show datapath mcast command.
Dev Vlans
-------- ----------------------
dev3 1
dev11 1
dev12 1
dev13 1
dev14 1
show datapath nat-pool
The following example shows the output of
show datapath nat-pool command.
Datapath NAT Pool Entries
-------------------------
ID Begin Source IP End Source IP Destination IP Flags
-- --------------- ------------- -------------- -----
show datapath route
The following example shows the output of
show datapath route command.
Route Table Entries
-------------------
Flags: L - Local, P - Permanent, T - Tunnel, I - IPsec, M - Mobile, A - ARP, D - Drop
IP Mask Gateway Cost VLAN Flags
--------------- --------------- --------------- ---- ---- -----
0.0.0.0 0.0.0.0 10.17.88.2 0 0
192.168.10.0 255.255.254.0 192.168.10.1 0 3333 D
0.0.0.0 255.255.255.192 10.17.88.59 0 1 L
Route Cache Entries
-------------------
Flags: L - local, P - Permanent, T - Tunnel, I - IPsec, M - Mobile, A - ARP, D - Drop
IP MAC VLAN Flags
--------------- ----------------- ----------- -----
10.17.88.2 00:0B:86:40:1C:A0 1 A
10.17.88.59 D8:C7:C8:C4:42:98 1 LP
192.168.10.1 D8:C7:C8:C4:42:98 3333 LP
show datapath sbr
The following example shows the partial output of
show datapath sbr command.
Source Based Routing Datapath Table