Siemens SCALANCE W1750D CLI - Page 470

CLI Commands
4.16 S
SCALANCE W1750D CLI
470 Function Manual, 03/2019, C79000-G8976-C452-04
VLAN Flags Ports
---- ------ -----
1 R dev3
1 R dev11
1 R dev12
1 R dev13
1 R dev14
show datapath vlan-mcast
The following example shows the output of
the show datapath vlan-mcast command.
Datapath VLAN Multicast Entries
---------------------------
VLAN Destinations
---- ------------
1 dev8
121 dev8, dev18, dev19, dev20, dev21
3333 dev3, dev8, dev22, dev23
show datapath vlan-port-mapping
The following example shows the partial output of the
show datapath vlan-port-mapping
command.
Datapath VLAN-Port-Mapping Table Entries
---------------------------
VLAN Port Users
---- ---- -----
The outputs of the
show datapath command indicates the following:
● ACL table allocation details for the AP.
● AP Datapath ACL Tables.
● List of ACL rules configured for the SSID and Ethernet port profiles.
● Bridge table entry statistics including MAC address, VLAN, assigned VLAN, destination
and flag information for the AP.
● Details of a DMO session.
● Multicast table statistics for the AP.
● Route table statistics for the AP.
● Datapath session table statistics for the AP
● Hardware packet statistics for the AP.